Teka Appliance Repair in Three Bridges

What does the F symbol mean on a Teka induction hob?

The F symbol on Teka induction hobs indicates that a cooking zone is activated but no suitable pot or pan has been detected. Place an induction-compatible pot or pan centrally on the cooking zone. The cookware must have a magnetic base and be the correct size for the zone. If the symbol persists with suitable cookware in place, contact a specialist technician as there may be a fault with the pan detection system.

What does the Err5 error mean on a Teka washing machine?

The Err5 error on Teka washing machines indicates a water level error where the required level has not been reached within 8 minutes. Ensure the water tap is fully open and has adequate pressure. Check that the drain hose is installed at the correct height (80-100 cm) and is not submerged in water. If problems persist, contact a specialist technician.

What does the C85 error mean on a Teka induction hob?

The C85 error on Teka induction hobs indicates that the pot or pan being used is not suitable for induction cooking. Switch off the hob and replace the cookware with induction-compatible pots or pans. Suitable cookware must have a magnetic base, such as cast iron or magnetic stainless steel. Use a magnet to test if your cookware is compatible - if the magnet sticks firmly to the base, the cookware is suitable.

What does the E3 error mean on a Teka refrigerator?

The E3 error on Teka refrigerators indicates a problem with the refrigerator compartment temperature sensor. This sensor monitors the temperature in the main fridge section. Contact a specialist technician as the sensor may need inspection and replacement. Temperature regulation in the refrigerator section may be affected until repaired.

What does the E5 error mean on a Teka dishwasher?

The E5 error on Teka dishwashers indicates a water intake malfunction where the appliance does not take in water correctly. Verify the water tap is open. Check the water intake hose for kinks or blockages. Inspect the inlet filter for debris. If the problem persists after these checks, contact a specialist technician.

What does SHOW, SHO or DEMO mean on my Teka oven display?

When SHOW, SHO or DEMO appears on your oven display, it means the demonstration mode is activated. In this mode, the oven functions normally but does not heat up. To disable demo mode, disconnect the oven from the power supply for at least 10 seconds, then reconnect it. On some models, you may need to press and hold the + and - buttons for 10 seconds after reconnecting.

How often should I clean the filters on my Teka dishwasher?

The filters should be cleaned regularly to prevent buildup of food particles and debris. It is essential to keep them clean as the dishwasher cannot function properly if the filters are clogged.

Why do my glasses come out white or cloudy from my Teka dishwasher?

White marks or cloudiness on glasses typically occurs when rinse aid is insufficient or the water hardness settings are incorrect. Lime traces remain on dishes when rinse aid levels are too low.

Why is there excessive foam inside my Teka dishwasher after a wash?

Excessive foam is usually caused by using too much detergent or using the wrong type of detergent. Only use detergents specifically designed for automatic dishwashers.

Why are my Teka dishwasher programmes taking a long time to finish?

Modern dishwashers use longer wash cycles to achieve better cleaning results while using less water and energy. This is normal operation for eco-friendly programmes.