Teka Appliance Repair in Langley Green & Tushmore

What does the E4 error mean on a Teka induction hob?

The E4 error on Teka induction hobs indicates a communication failure between the user interface and the induction heating element. Switch off the hob at the mains and wait 10 minutes before switching it back on. If the error persists, contact a specialist technician as the control board or wiring may need inspection.

What does the Err8 error mean on a Teka washing machine?

The Err8 error on Teka washing machines indicates that water has exceeded the protective level, triggering the overflow protection system. Contact a specialist technician as this error indicates a fault with the water level sensing system or inlet valve that requires professional repair.

What does the Err2 error mean on a Teka washing machine?

The Err2 error on Teka washing machines indicates a drainage error where water has not drained within 6 minutes. Clean the pump filter located at the front bottom of the machine. Check the drain hose for blockages or kinks. Ensure the drain hose is not submerged in water. If the problem persists, contact a specialist technician.

What does the E1 error mean on a Teka dishwasher?

The E1 error on Teka dishwashers indicates a water filling issue or that the anti-flooding system (Acquastop) has been triggered. Check that the water tap is fully open and verify the water pressure is adequate. Inspect the inlet hose for kinks or blockages. If the anti-flooding system has been triggered due to a leak, turn off the water supply and contact a specialist technician.

What does the U400 error mean on a Teka induction hob?

The U400 error on Teka induction hobs indicates an incorrect electrical connection where the hob has been connected to an inappropriate power supply. Do not use the hob. Contact a qualified electrician to verify the electrical installation meets the manufacturer's requirements. This error cannot be cleared until the connection is corrected.

Why are my Teka dishwasher programmes taking a long time to finish?

Modern dishwashers use longer wash cycles to achieve better cleaning results while using less water and energy. This is normal operation for eco-friendly programmes.

How do I reset my Teka induction hob after a power cut?

Disconnect the hob from power by switching off at the mains or unplugging it. Wait at least 10 minutes to allow the system to reset, then reconnect and attempt to turn it on again.

When should I replace the carbon filter on my Teka cooker hood?

Carbon filters last between three and six months depending on usage conditions. The activated carbon filter cannot be washed or regenerated and must be replaced when exhausted.

How do I use combination cooking (microwave and grill) on my Teka microwave?

Press the COMBI button to select the combination mode. C-1 uses 55% microwave and 45% grill power, suitable for fish and similar foods. C-2 uses 36% microwave and 64% grill power. Set the cooking time using the dial and press start.

How should I maintain my Teka dishwasher?

Clean the outer surfaces and door lining regularly using a soft cloth moistened with water or mild detergent suitable for painted surfaces. Clean the door gaskets with a damp sponge. After every wash, turn off the water supply and leave the door slightly open to prevent moisture and odours from being trapped inside.