Faber Appliance Repair in Southgate

Why are the lights not working on my Faber cooker hood?

If the lights on your Faber cooker hood do not illuminate but the motor works, it may be a bulb, LED strip, or driver failure. Switch off at the mains before any inspection. For halogen models, you may check and replace the bulb with a matching type, avoiding direct skin contact with the new bulb. For LED models, contact a qualified technician as LED components require technical expertise to replace. Consult your instruction manual for model-specific bulb specifications.

Why is my Faber cooker hood not extracting properly?

Reduced extraction on a Faber cooker hood is usually caused by clogged filters, blocked ducting, or stuck damper flaps. Clean the grease filters thoroughly, replace charcoal filters for recirculation hoods, check the exterior vent for blockages, and ensure ducting is not kinked. If suction remains weak, contact a qualified technician.

Why does my Faber cooker hood run at high speed for only 6 minutes?

When your Faber cooker hood runs at maximum speed and automatically reduces after 6 minutes, this indicates the intensive speed mode is functioning correctly. This timed feature provides maximum extraction power for heavy cooking tasks such as frying or grilling, then automatically returns to a lower speed to conserve energy. This is normal operation, not a fault.

Why are all LEDs flashing three times on my Faber cooker hood?

When all LEDs flash three times simultaneously on a Faber cooker hood, it confirms that the filter saturation alarm has been successfully reset. This is a confirmation signal, not an error, and no action is required.

Why is my Faber cooker hood making excessive noise or vibrating?

Excessive noise or vibration from a Faber cooker hood is commonly caused by incorrect installation, undersized ducting, or a loose mounting. Verify the hood is securely fixed and that ducting maintains the recommended diameter throughout the entire run without kinks or restrictions. Dirty filters can also increase noise levels. If vibrations persist after checking installation, contact a qualified technician as the motor or impeller may require inspection.

Why is a ducted cooker hood quieter than a recirculating one?

Ducted hoods are quieter because the extracted air passes directly through the ducting without obstruction. In recirculating hoods, the air must pass through charcoal filters in addition to grease filters, creating extra resistance that increases noise levels. This additional filtration step is why recirculating hoods tend to be louder.

Why is my Faber cooker hood noisy?

Noise is generated by the airflow passing through the grease filters during operation. Common causes of increased noise include dirty or clogged filters, undersized ducting, or obstructions in the duct run. Clean or replace filters regularly and ensure ducting is the correct diameter throughout the entire run.

What speed setting should I use on my Faber cooker hood?

Use low speed settings for normal everyday cooking such as boiling pasta or simmering sauces. Reserve high speeds for foods that produce strong odours or smoke, such as frying or grilling.

How long should I leave my Faber cooker hood running after cooking?

Leave the hood running on a low speed for approximately 10 minutes after you finish cooking. This ensures all residual odours and steam are removed from the kitchen.

Is grease on the filters a fire hazard?

Grease deposited on filters is inflammable, which is why regular maintenance is essential. Clean or replace filters according to the recommended schedule based on approximately 3 hours of daily use. Never allow excessive grease to accumulate on the filters.