Faber Appliance Repair in Northgate & West Green

Why is my Faber cooker hood not extracting properly?

Reduced extraction on a Faber cooker hood is usually caused by clogged filters, blocked ducting, or stuck damper flaps. Clean the grease filters thoroughly, replace charcoal filters for recirculation hoods, check the exterior vent for blockages, and ensure ducting is not kinked. If suction remains weak, contact a qualified technician.

Why does my Faber cooker hood turn off automatically after 30 minutes?

If your Faber cooker hood switches off automatically after 30 minutes, the delay function is active. This feature allows the hood to continue extracting residual cooking odours after you finish cooking, then shuts off automatically. To deactivate this function, press and hold the delay button for approximately 3 seconds according to your model's instructions. This is a programmed feature, not a malfunction.

What does it mean when the LED flashes twice on a Faber cooker hood?

Two LED flashes on a Faber cooker hood can indicate either that the remote control receiver has been activated, or that the activated charcoal filter alarm has been enabled. This is a confirmation signal showing the hood has registered your command.

Why are all LED buttons flashing twice on my Faber cooker hood?

When all LED buttons flash twice simultaneously on a Faber cooker hood, it indicates that the control lock mode has been activated or deactivated. This safety feature prevents accidental changes to hood settings during cleaning. To toggle the lock, press and hold the designated button according to your model's instructions. This is a confirmation signal, not an error.

Why is my Faber cooker hood motor humming but not spinning?

If your Faber cooker hood motor hums but the fan does not spin, this typically indicates a faulty start capacitor or a seized motor. Switch off the hood at the mains immediately and do not continue using it in this condition. Symptoms may vary by model, so consult your instruction manual for model-specific guidance. Contact a qualified technician for diagnosis and repair.

What are the benefits of LED lighting in Faber cooker hoods?

LED lighting in Faber cooker hoods provides bright, even illumination across the entire cooking area while using significantly less energy than traditional halogen bulbs. LEDs also have a much longer lifespan and produce less heat, contributing to the overall energy efficiency of the hood.

What cleaning products should I avoid using on my Faber cooker hood?

Avoid using alcohol-based or silicone-based products to clean the inside or outside of your cooker hood, as these can damage the finish. Never use abrasive cleaners, scouring pads, or products containing chlorine. Use only mild soap with a soft cloth or sponge.

Where can I find the user manual for my Faber cooker hood?

User manuals for Faber cooker hoods are available on the individual product pages on the Faber UK website. Locate your hood model and download the manual in PDF format from the product page.

How often should I clean the metal grease filters on my Faber cooker hood?

Metal grease filters should be washed every 2 months under normal cooking conditions (up to 3 hours of use per day). This equates to approximately every 100 hours of hood operation.

What is the minimum installation height for a Faber cooker hood above a gas hob?

The minimum distance between the cooker hood and a gas hob must be at least 75cm. This increased distance is required due to the open flames and heat production from gas burners.