Faber Appliance Repair in Bewbush & North Broadfield

Why are all LEDs flashing three times on my Faber cooker hood?

When all LEDs flash three times simultaneously on a Faber cooker hood, it confirms that the filter saturation alarm has been successfully reset. This is a confirmation signal, not an error, and no action is required.

Why are the control panel buttons not responding on my Faber cooker hood?

Control panel buttons not responding on a Faber cooker hood may be caused by grease buildup, loose cable connections, or a faulty control board. Switch off at the mains, clean the control panel with a soft damp cloth, and leave unplugged for 10 minutes to reset. Symptoms may vary by model, so consult your instruction manual for model-specific guidance. If the issue persists, contact a qualified technician.

Why are the lights not working on my Faber cooker hood?

If the lights on your Faber cooker hood do not illuminate but the motor works, it may be a bulb, LED strip, or driver failure. Switch off at the mains before any inspection. For halogen models, you may check and replace the bulb with a matching type, avoiding direct skin contact with the new bulb. For LED models, contact a qualified technician as LED components require technical expertise to replace. Consult your instruction manual for model-specific bulb specifications.

Why is my Faber cooker hood motor humming but not spinning?

If your Faber cooker hood motor hums but the fan does not spin, this typically indicates a faulty start capacitor or a seized motor. Switch off the hood at the mains immediately and do not continue using it in this condition. Symptoms may vary by model, so consult your instruction manual for model-specific guidance. Contact a qualified technician for diagnosis and repair.

Why does my Faber cooker hood turn on briefly every hour?

If your Faber cooker hood activates for approximately 10 minutes every hour, the 24-hour air circulation mode is enabled. This eco-friendly feature maintains fresh air in your kitchen by periodically ventilating at low speed throughout the day. To deactivate this mode, press and hold the designated button for approximately 2 seconds with the motor and lights off. Consult your instruction manual for model-specific controls.

What is the minimum installation height for a Faber cooker hood above an electric or induction hob?

The minimum distance between the cooker hood and an electric or induction hob is 65cm. If the hob has a larger cooking area, the hood may need to be positioned slightly higher to provide complete coverage.

Where should the ducting from my Faber cooker hood terminate?

Ducting must terminate outside of your home. A crawl space, attic, basement, or garage does not meet the definition of outside and should not be used as a termination point for the ducting.

What are the benefits of LED lighting in Faber cooker hoods?

LED lighting in Faber cooker hoods provides bright, even illumination across the entire cooking area while using significantly less energy than traditional halogen bulbs. LEDs also have a much longer lifespan and produce less heat, contributing to the overall energy efficiency of the hood.

What speed setting should I use on my Faber cooker hood?

Use low speed settings for normal everyday cooking such as boiling pasta or simmering sauces. Reserve high speeds for foods that produce strong odours or smoke, such as frying or grilling.

How do I clean the metal grease filters on my Faber cooker hood?

Wash the metal grease filters by hand using warm water with neutral or acid-free soap, or place them in the dishwasher. After washing, allow the filters to dry completely before reinstalling.