Faber Appliance Repair in Broadfield

Why does my Faber cooker hood turn off automatically after 30 minutes?

If your Faber cooker hood switches off automatically after 30 minutes, the delay function is active. This feature allows the hood to continue extracting residual cooking odours after you finish cooking, then shuts off automatically. To deactivate this function, press and hold the delay button for approximately 3 seconds according to your model's instructions. This is a programmed feature, not a malfunction.

Why are all LEDs flashing three times on my Faber cooker hood?

When all LEDs flash three times simultaneously on a Faber cooker hood, it confirms that the filter saturation alarm has been successfully reset. This is a confirmation signal, not an error, and no action is required.

Why does my Faber cooker hood run at high speed for only 6 minutes?

When your Faber cooker hood runs at maximum speed and automatically reduces after 6 minutes, this indicates the intensive speed mode is functioning correctly. This timed feature provides maximum extraction power for heavy cooking tasks such as frying or grilling, then automatically returns to a lower speed to conserve energy. This is normal operation, not a fault.

Why is my Faber cooker hood motor humming but not spinning?

If your Faber cooker hood motor hums but the fan does not spin, this typically indicates a faulty start capacitor or a seized motor. Switch off the hood at the mains immediately and do not continue using it in this condition. Symptoms may vary by model, so consult your instruction manual for model-specific guidance. Contact a qualified technician for diagnosis and repair.

What does it mean when the LED flashes twice on a Faber cooker hood?

Two LED flashes on a Faber cooker hood can indicate either that the remote control receiver has been activated, or that the activated charcoal filter alarm has been enabled. This is a confirmation signal showing the hood has registered your command.

What is the Faber Long Lasting charcoal filter and how do I maintain it?

The Long Lasting filter is a reusable active carbon filter with multi-layer technology that can be washed in the dishwasher every 3-4 months and lasts for up to 3 years of normal use. After washing, dry it at room temperature in a vertical position or in an oven at 50°C.

Why is my Faber cooker hood noisy?

Noise is generated by the airflow passing through the grease filters during operation. Common causes of increased noise include dirty or clogged filters, undersized ducting, or obstructions in the duct run. Clean or replace filters regularly and ensure ducting is the correct diameter throughout the entire run.

What is the minimum installation height for a Faber cooker hood above an electric or induction hob?

The minimum distance between the cooker hood and an electric or induction hob is 65cm. If the hob has a larger cooking area, the hood may need to be positioned slightly higher to provide complete coverage.

What is K-Link technology on Faber cooker hoods?

K-Link is Faber's wireless technology that connects compatible Faber induction hobs and cooker hoods using radio signals. When enabled, the hood automatically adjusts its extraction power based on the cooking intensity of the hob, optimising performance without manual adjustment while reducing energy waste and unnecessary noise.

What is the minimum installation height for a Faber cooker hood above a gas hob?

The minimum distance between the cooker hood and a gas hob must be at least 75cm. This increased distance is required due to the open flames and heat production from gas burners.