Vasco Appliance Repair in Langley Green & Tushmore

Why does my Vasco radiator with blower make noise after turning off?

This is normal operation. Vasco radiators with blower units have a post-ventilation cycle that continues briefly after heating stops. The blower will stop automatically once this cycle completes.

What does a blinking green LED mean on a Vasco E-Volve controller?

A blinking green LED on a Vasco E-Volve controller indicates frost protection mode is active or open window detection has been triggered. Close any open windows or doors and the radiator will resume normal operation once the temperature stabilises.

Why is my Vasco electric radiator not heating even though the remote shows it's cold?

The RF remote temperature reading is indicative only and may differ from the actual temperature at the radiator's sensor, located at the bottom rear of the unit. Cold draughts from open doors or windows can affect sensor readings. Consider disabling open window detection or calibrating the temperature sensor.

Why won't my Vasco E-Volve WiFi module connect to the internet?

The Vasco E-Volve WiFi module only supports 2.4 GHz networks. Many modern routers and WiFi extenders operate on 5 GHz, which is incompatible. Check your router settings to ensure the 2.4 GHz band is enabled and move the module closer to the router during initial setup.

What does a blinking red LED mean on a Vasco E-Volve controller?

A blinking red LED on a Vasco E-Volve controller indicates that boost mode is active, providing rapid heating to 30°C for one hour. The radiator will automatically exit boost mode after the set duration, or you can cancel it manually by pressing the boost button again.

Do I still need to place radiators under windows?

In older, poorly insulated homes, placing radiators under windows remains advisable to combat cold draughts from single or poor-quality glazing. However, in well-insulated homes built within the last 20 years, radiators can be positioned anywhere due to improved glazing and insulation.

Where is the best place to position a Vasco radiator?

Install radiators 3 to 5 centimetres from the wall and at least 10 to 15 centimetres above the floor. This clearance allows air to circulate properly around the radiator, ensuring radiant heat is distributed effectively throughout the room.

How do I calculate the correct heat output for a Vasco radiator?

Use the formula: square metres × watts per square metre = required heat output. A radiator's heat delivery is expressed in watts, and the required output depends on the room type, desired temperature, insulation level, and heating system type.

How often should I clean and replace the filters on my Vasco ventilation system?

Clean ventilation filters by vacuuming every three months. Replace filters completely every six months to maintain effectiveness.

Why is ventilation filter maintenance important?

Filters remove unhealthy substances from outdoor air including pollen, dust, and contaminants. They also prevent contamination of the air ducts, which can otherwise become a breeding ground for bacteria.