Vasco Appliance Repair in Bewbush & North Broadfield

Why does my Vasco radiator stay cold when the heating is on?

A cold Vasco radiator when the heating is on may indicate a stuck valve or an issue with the valve insert. Do not attempt to disassemble or manipulate valve components yourself. Contact a qualified heating engineer to inspect and repair the valve mechanism.

Why does my Vasco radiator with blower make noise after turning off?

This is normal operation. Vasco radiators with blower units have a post-ventilation cycle that continues briefly after heating stops. The blower will stop automatically once this cycle completes.

Why won't my Vasco RF thermostat pair with the electric radiator?

The RF remote control and RF receiver are not pre-paired from the factory and must be connected following the instructions in the thermostat manual. Ensure both devices have power, position them close together during pairing, and follow each step carefully. If pairing fails repeatedly, press and hold the MEMO button on the RF receiver for more than 10 seconds to cancel and retry the pairing process.

Why is my Vasco radiator making a hissing or rushing water sound?

A hissing or rushing water sound from a Vasco radiator typically indicates excessive water flow at the valve, often caused by high system pressure or debris partially blocking the valve. The heating system may require water-side balancing to ensure proper flow distribution. Contact a qualified heating engineer to diagnose and resolve the issue.

What does a blinking orange LED mean on a Vasco E-Volve controller?

A blinking orange LED on a Vasco E-Volve controller indicates that manual override is active via the MEMO button. This temporarily overrides the programmed schedule. Press the MEMO button again to cancel the override.

Why won't my Vasco radiator cool down when the heating is off?

This indicates the valve is not closing properly, allowing hot water to continue flowing through the radiator. Contact a qualified heating engineer to inspect and replace the valve mechanism.

How long does it take to install a Vasco infrared panel?

Installation is straightforward once the power cable is correctly positioned. A qualified electrician can typically complete the installation in approximately 15 minutes. Infrared panels require no annual maintenance, and if a panel fails, only that room loses heat rather than the entire home.

What is the difference between the Vasco Boost and Boost H ventilation systems?

The standard Vasco Boost recovers heat from exhaust air to warm incoming fresh air. The Boost H includes an enthalpy heat exchanger that recovers both heat and moisture from the outgoing air, providing improved indoor comfort during the heating season by maintaining better humidity levels.

How do I clean a Vasco radiator?

Dust radiators regularly using a vacuum cleaner or damp cloth. For ladder-style or vertical designer radiators, use a long feather duster to reach between the tubes. Convective heating units collect dust particularly easily and benefit from regular attention.

How do I calculate the correct heat output for a Vasco radiator?

Use the formula: square metres × watts per square metre = required heat output. A radiator's heat delivery is expressed in watts, and the required output depends on the room type, desired temperature, insulation level, and heating system type.