Zanussi Appliance Repair in Ifield

What does Zanussi washing machine error code E10 or E11 mean?

Error code E10 or E11 on a Zanussi washing machine indicates a water inlet problem. The machine is not taking in water or not receiving enough water. Switch off and unplug the appliance before any inspection. Check that the water tap is fully open, the inlet hose is not kinked, and the inlet filter is not blocked.

What does Zanussi dishwasher error code i60 mean?

Error code i60 on a Zanussi dishwasher indicates a heating problem. The water temperature inside the appliance is too high or the temperature sensor has malfunctioned. Switch off and unplug the dishwasher. Ensure the incoming water temperature does not exceed 60°C. Clean the filter and sump, then reconnect and run a test cycle. If the error persists, contact a qualified technician.

What does Zanussi dishwasher error code i70 mean?

Error code i70 on a Zanussi dishwasher indicates a temperature sensor problem in the sump. Switch off and unplug the dishwasher. Check the filter and sump for foam, suds, or debris. Clean all filters thoroughly, reconnect, and run a test cycle. If the error persists, contact a qualified technician.

What does Zanussi dishwasher error code i10 mean?

Error code i10 on a Zanussi dishwasher indicates a water inlet problem. No water is entering the appliance. Switch off and unplug the dishwasher before any inspection. Check the water tap is open, the inlet filter is clean, and no other appliances are reducing water pressure.

What does Zanussi washing machine error code EF0 or EF3 mean?

Error code EF0 or EF3 on a Zanussi washing machine indicates a water leak, over-foaming, or unbalanced load. Close the water supply immediately. Do not step on water that may be in contact with the appliance while plugged in. Unplug only if you can do so safely. Check the door seal for leaks, reduce detergent usage to prevent over-foaming, and ensure laundry is evenly distributed. If the problem persists, contact a qualified technician.

What does the E20 error code mean on my Zanussi washing machine?

The E20 error code indicates a drainage problem. The drain filter may be blocked or the drain hose may be kinked or incorrectly positioned. Clean the drain filter and check that the drain hose is not obstructed. If the pump has overheated, switch off the machine for 1 to 2 hours to allow the safety thermostat to reset, then try again.

How often should I clean my Zanussi cooker hood metal filters?

Clean the metal filters after approximately 30 hours of use. They can be washed in a dishwasher using an intensive cycle at minimum 65°C, or hand-washed.

Why does my Zanussi washing machine show an E11 error code?

The E11 error code indicates that the machine is not filling with water. Check that the water supply is turned on, hoses are correctly attached and not kinked, and the inlet filter screens are not blocked.

Why won't my Zanussi washing machine spin?

Make sure the machine is level by raising or lowering the feet using a spanner and check with a spirit level. Ensure the machine is placed on a stable, hard floor. A very small load can cause balance problems during the spin phase, leading to excessive vibration.

What does the i30 error code mean on my Zanussi dishwasher?

The i30 error code indicates that water has collected in the base of the appliance, triggering the anti-flood protection device. This may be caused by an internal leak, in which case a visit from a qualified technician is recommended. Occasionally, excessive foam can also trigger this error - switch off the dishwasher at the mains and leave it overnight to allow the foam to disperse before trying again.