De Dietrich Appliance Repair in Northgate & West Green

What does the D07 error code mean on a De Dietrich dishwasher?

The D07 error code indicates the overflow or leak protection system has detected a potential leak. Check for visible leaks and inspect door seals. If no obvious leak is found, contact a specialist appliance technician.

What does the F1 error code mean on a De Dietrich hob?

The F1 error code indicates a malfunction in the front-left cooking area. Turn off the hob and allow it to cool completely for at least 30 minutes. Avoid using the affected zone and contact a specialist appliance technician to diagnose and repair the specific heating zone.

What does the D08 error code mean on a De Dietrich dishwasher?

The D08 error code indicates the upper spray arm is not functioning properly. Remove and clean the spray arm, clearing any debris from the holes, and check it spins freely. If the fault continues, contact a specialist appliance technician.

What does the F7 error code mean on a De Dietrich hob?

The F7 error code indicates the hob's electronic components have overheated. Turn off immediately and allow to cool for at least 30 minutes. Ensure ventilation is not obstructed. If the error reappears, contact a specialist appliance technician.

What does the E01 error code mean on a De Dietrich boiler?

The E01 error code indicates an ignition failure or the boiler's safety thermostat has activated due to overheating. Check the hydraulic pressure gauge. If pressure is 1 bar or higher, press the RESET button. If the error reappears or the boiler fails to fire, do not continue attempting to reset. Contact a Gas Safe registered engineer.

How do I clean the spray arms on my De Dietrich dishwasher?

Both the upper and lower spray arms can be removed for routine cleaning to prevent blockages. Wash them under running water, carefully clearing any debris from the nozzle holes, then replace them in their seats.

How do I use the pyrolytic cleaning function on my De Dietrich oven?

Before starting pyrolysis, remove all accessories that are not pyrolysis-safe (sliding rails, baking trays, chrome-plated grills) and any cookware from the oven. The side grills may remain inside. Select a pyrolytic cleaning programme and the oven will heat to a very high temperature (up to 500°C), turning all residues to ash. Do not touch the oven or nearby surfaces during or immediately after the cleaning cycle, as they become extremely hot.

How do I adjust the rinse aid dosage on my De Dietrich dishwasher?

The rinse aid dosage can be adjusted from level 1 to 5. The default setting is usually level 2. If glasses show water marks or streaks after washing, increase the dosage. If dishes appear sticky or have a bluish film, reduce the dosage. Check your user manual for the specific adjustment procedure for your model.

What pressure should my De Dietrich boiler show?

The hydraulic pressure should typically be between 1.5 and 2 bar for normal operation. If the pressure drops below 1 bar, you will need to repressurise the system by topping up with water following the procedure in your user manual.

How do I prevent bad odours in my De Dietrich washing machine?

After each wash, leave the door open for a while to allow air to circulate freely inside the machine. This helps prevent mould and mildew growth that causes unpleasant odours.